234 Chapter 23: Crossfades (Automation)
PRO Series Live Audio Systems
Owner’s Manual
Manually controlling a crossfade
The controls in the automation section of
the output bay let you manually override
the crossfade, as described in the
following table.
Control Function during crossfade
cancel button Pauses the crossfade. Pressing the cancel button again, while the
crossfade is paused, cancels the crossfade.
Note: The level of the control on which the crossfade is operating
will remain at the point at which it was paused. If you restart the
crossfade the control will travel over the full crossfade period, that
is, if you stop (rather than pause) a five-second crossfade at two
seconds and restart it, it will take the control five seconds to move
to the final position, and not three seconds.
now button Pressing this button while the crossfade is paused (by pressing the
cancel button), continues the crossfade.
ok button Jumps to the end of the crossfade, effectively cancelling the
remaining time to the end of the crossfade.
Jogwheel Rotate the jogwheel to slow down/speed up the rate of crossfade.
The speed of rotation will determine the rate of crossfade.
Rotating the jogwheel quickly in a clockwise direction will speed up
the crossfade and rotating it an anti-clockwise direction slows it
down.
To Next Page
Loading...
Need help?
General
