128 Chapter 10: Stereo Linking
PRO Series Live Audio Systems
Owner’s Manual
Changing the linking options
You can choose which control options will be linked across the channel pair, either
globally or on a per pair basis. The per pair settings always override the global ones.
For details of the linked parameters for each section, see Appendix O "Parameters
Affected By Stereo Linking" on page 539.
>> To set the global default stereo linking options
1 At the GUI, choose
home
PreferencesLinking. This
will open the Stereo Linking Default
Settings window (shown right),
which is divided into channel types.
2 In a channel section, select the
desired default stereo linking options
and then click the Change Existing
button directly underneath.
Repeat as necessary for any other
channels.
Selected control options will be linked across
the channel pair of the appropriate type.
Unselected controls remain independent on
each channel.
>> To set the stereo linking options for a channel pair
1 Make sure that one of the paired channels is selected and its configuration
processing area is assigned to the GUI channel strip. Then open the Stereo
Linking Options by clicking the st. linking options button in the GUI channel
strip.
2 Select the controls that you want linked across the channel
pair. A typical Stereo Linking Options window is shown
right. The active options will be channel dependent.
3 Click CLOSE.
To Next Page
Loading...
Need help?
General
