196 Chapter 19: Assignable Controls (I Zone)
PRO Series Live Audio Systems
Owner’s Manual
>> To switch between the overview and zoom displays
Do one of the following:
• To open the overview display from one of the zoom displays, press any of the LCD
buttons in the I zone.
• To open a zoom display from the overview display, press the desired LCD button in
the I zone.
>> To navigate the zoom displays
If you are at a zoom display and you want to go to another one (for example, to adjust
a fader or front panel control) use the left and right arrow buttons in the assignable
controls panel (see “Rack and unit control navigation” on page 191). For diagrams of
the available zoom displays, see Figure 24 “I zone LCD button assignments in the
overview display” on page 195.
>> To adjust a group of faders simultaneously in the overview display
Make sure the overview display is shown on the GUI and adjust the appropriate control
knob in the I zone. The group of faders will adjust in equal amounts from their relative
positions. However, continual adjustment will eventually take all of the group’s faders
to the maximum/minimum extent.
>> To adjust a single fader in a zoom display
If necessary, navigate the desired zoom display (containing the fader you want to
change) to the GEQ window. In the I zone, adjust the desired control knob.
Note: You can also adjust a single fader in the overview display using drag, or in the
rack view (with the GEQ window closed).
>> To operate a button or control knob of a GEQ
For details, see “To operate a button of an effect” on page 193 and “To operate a control
knob of an effect” on page 193.
To Next Page
Loading...
Need help?
General
