Using the PRO Series updater 413
PRO Series Live Audio Systems
Owner’s Manual
The update procedure will then
automatically start by uploading
files to the GUI/MC (as shown
right).
During the update procedure, leave
all of the system devices switched
on (see the Caution at the start of
this section).
Throughout the update procedure
the device blocks will change
colour according to their update
status (see Table 23 “Description of
the updater screen device blocks”
on page 409). The status bar will
show the progress of the current
action.
When the update procedure has
finished, an Upgrade complete
window will open (as shown right).
10 Click Ok to close the Upgrade
complete window.
11 Click Quit. The PRO Series Control
Centre and all the units will return
to normal operating mode.
If any units have failed to update,
instead of clicking Quit you can
select them and start the update
procedure again.
12 Power cycle the system by
switching the PRO Series Control
Centre and all of the system units
off and then on again.
13 When the system has powered up fully and the control centre is ready for normal
operation, repeat step 12 to ensure that the licensing system is enabled.
>> To update your PRO Series Live Audio System with a previous version of
host software
The procedure is the same as if you are installing the latest version of host software (as
detailed above), just select the file of the older software version you want from the
homePreferencesUpgrade submenu instead of the latest one.
To Next Page
Loading...
Need help?
General
