EasyManuals Logo

Mindray ePM 12MC User Manual

Mindray ePM 12MC
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
3 - 14
3.10 Stopping a Parameter Measurement
To stop monitoring a parameter, follow this procedure:
1. Remove the corresponding sensor from the patient.
2. Disconnect the sensor from the patient cable.
3. Disconnect the patient cable from the parameter module.
4. If you are using the disposable sensor, discard it.
3.11 General Operation
This section describes the operations that are generally used when monitoring a patient.
3.11.1 Switching On or Off a Parameter
You can also manually switch on or off a parameter when its module is connected. If setting parameter switches
is not password protected, follow this procedure to set parameter switches:
1. Access Parameters On/Off by any of the following ways:
◆ Select the Screen Setup quick key → select the Parameters On/Off tab.
◆ Select the Main Menu quick key → from the Parameter column select Parameters On/Off.
2. Enable or disable desired parameters.
If setting parameter switches is password protected, to set parameter switches, switch on Parameters On/Off
Protected. For more information, see 27.11The Other Settings.
When a parameter is switched off, the monitor stops data acquisition and alarming for this measurement.
NOTE
• When a parameter is manually switched off and the corresponding parameter module is plugged in,
you cannot monitor this parameter.
3.11.2 Displaying Parameter Numerics and Waveforms
You can configure the parameter numerics, waveforms, and their sequence displayed on the normal screen. To
do so, follow this procedure:
1. Access Tile Layout in either of the following ways:
◆ Select the Screen Setup quick key → select the Tile Layout tab.
◆ Select the Main Menu quick key → from the Display column select Tile Layout.
2. Select a parameter numeric area or waveform area, and then from the popup list select an element you
want to display in this area. The parameters and waveforms you did not select will not displayed.
3.11.3 Displaying the Parameter List
You can display trends of HR, SpO
2
, RR, and NIBP/IBP in the parameter numerics area. To do so, follow this
procedure:
1. Access Tile Layout in either of the following ways:
◆ Select the Screen Setup quick key → select the Tile Layout tab.
◆ Select the Main Menu quick key → from the Display column select Tile Layout.
2. From the parameter numerics area, select where you want to display the parameter list. From the popup
list, select Parameter List.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray ePM 12MC and is the answer not in the manual?

Mindray ePM 12MC Specifications

General IconGeneral
BrandMindray
ModelePM 12MC
CategoryMedical Equipment
LanguageEnglish

Related product manuals