5 - 3
5.3.4 Loading Patient Information from the ADT Server
If the monitor is connected with the Admit-Discharge-Transfer (ADT) server through the eGateway. You can load
patient information from ADT server to the monitor. To do so, follow this procedure:
1. Enter the Find Patient menu in either of the following ways:
◆ Select the Main Menu quick key → from the Patient Management column select Find Patient.
â—† Select Find Patient from the Patient Management menu.
2. Input query criteria.
3. Select Query. Then a list pops up, including all the patients that meet the query criteria.
4. Select a patient from the patient list, and then select Import. Corresponding patient information in the
monitor will be updated.
• You can load patient information from the ADT server only when ADT Query is enabled. For more
information, see 7.5Viewing Other Patients.
• Loading patient information from the ADT server updates only patient information in the monitor.
The patient’s monitoring data is not changed and the patient is not discharged.
5.4 Exporting Patient Data
To export the data of the current patient and discharged patients, follow this procedure:
1. Connect the USB drive to the monitor’s USB connector.
2. Access the Discharged Patients dialog box by either of the following ways:
â—† Select the Discharged Patients quick key.
◆ Select the Main Menu quick key → from the Patient Management column select Discharged
Patients.
3. From the patient list select desired patients.
4. Select Export Data.
5.5 Deleting Patient Data
To delete the data of discharged patients, follow this procedure:
1. Access the Discharged Patients dialog box by either of the following ways:
â—† Select the Discharged Patients quick key.
◆ Select the Main Menu quick key → from the Patient Management column select Discharged
Patients.
2. From the patient list select desired patients.
3. Select Delete.
To Next Page
Loading...
Need help?
General
