Minebea Intec PR5900 - Page 274

Note:
During the restoring process, all data selected on the device is overwritten with the data
from the backup.
The network settings are not overwritten.
The following applies:
- Restoring the setup data will replace all settings and therefore delete all settings
made after the backup.
- Restoring the calibration data will replace the current calibration and therefore
delete all calibrations made after the backup.
- Restoring the user management data will overwrite all users and therefore delete all
users created after the backup.
- Restoring the application data will overwrite all settings and therefore delete all
settings made after the backup.
- Restoring the database will overwrite all tables and entries in the database.
- Licenses will not be overwritten if:
- CAL switch 2 is closed or
- [W&M mode] is selected and the parameter [Settings locked] is activated for at
least one weighing point and
- the board number in the restore le corresponds to the board number of the
device.
- Licenses will not be overwritten if CAL switch 1 is closed or [W&M mode] is selected
and the parameter [Settings locked] is activated for at least one weighing point.
Accessible via MENU – [Operating] - [System maintenance] - [Restore].
System maintenance @admin
Backup
Restore
Export
Import
Alibi memory maintenance
SD card maintenance
Create service report
Shutdown & Power off
Update software
Factory reset
Test hardware
Select and conrm [Restore].
The window listing the available storage media is shown.
Process Controller Maxxis 5 PR 5900 6 System maintenance
Minebea Intec EN-272