Minebea Intec PR5900 - Mettler-Scale

Note:
A host name can only be entered if
- A name server exists in the network that knows the device host name.
- [Operating]- [System setup]- [Network parameters]- [Use DHCP] is activated
for the PR 5900 (otherwise the PR 5900 does not learn the address of the name
server).
[Default] soft key
Settings are reset to factory settings.
4.7.10 Mettler-Scale
In this menu item (Weighing points), the Mettler-Scale weighing electronics are
assigned to a logical weighing point and congured.
- Example of parameter settings in the Application menu.
- [Interface] (serial), see Chapter 4.7.10.1.
- [Parameters] (weighing electronics), see Chapter 4.7.10.2.
PR 5900 can communicate with the Mettler-Scale via the MT-SICS protocol. A maximum
of four scales can be connected via serial interfaces. Communication is serial.
The determination and transmission of weight depends strongly on the scale. Weight
values up to seven digits plus preceding +/- sign can be displayed. The maximum
capacity (Max) is already set in the Mettler-Scale and cannot be modied via the MT-SICS
protocol.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Weighing point] - [Mettler-Scale] .
3. Press the [Save] soft key to save the settings.
WP-C Max 10000kg d= 1kg
6651
+
kg
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
PR-Net weighing point
Pendeo Process
Parameters
After saving, the weight value of the scale is displayed.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-216