Minebea Intec PR5900 - Update Software for Remote Terminal

6.9.4 Update software for remote terminal
In this menu item (under Update software), the existing software for the remote terminal
is updated.
Prerequisite
- The remote terminal is connected to the device.
Accessible via MENU - [Operating]- [System maintenance]- [Update software]- [Update
software for remote terminal] .
Update software
Update software
Update via FlashIt!
Update software for remote terminal
Remove application
Restore software from SD card
Select media for update remote terminal
Attached storage devices
USB stick
Network share connections
Alibi
Backups
Exports
ONECLICKUPDATE
Reports
Software
Example: Attached storage devices [USB stick], see Chapter 6.9.2.3.
The window appears on the device display after the le has been loaded onto the
device.
8. The next les can then be loaded.
After the last le has been loaded, the window appears again on the device
display.
9. Press the EXIT key to stop the ash process.
The device runs a cold start.
Select and conrm [Update software for remote terminal].
6 System maintenance Process Controller Maxxis 5 PR 5900
EN-329 Minebea Intec