Minebea Intec PR5900 - Shutdown & Power off (Without SD Card)

Shutdown & Power off @admin
?
WARNING!
After pressing 'Continue', the device must be
disconnected from the power supply.
Cancel Continue
6.8.1 Shutdown & Power o (without SD card)
CAUTION
Possible data loss!
If no SD card is inserted or the card cannot be read, no data is saved after the [Continue]
soft key is pressed.
An SD card must be inserted and detected by the device.
A prompt window opens if no SD card is inserted or the card cannot be read.
Shutdown & Power off
?
Cannot access SD card.
Stop and switch off without saving
a backup to the SD card?
Cancel Continue
6.9 Update software
In this menu item (under System maintenance), the software on the device is replaced
with the latest software.
2. Press the [Continue] soft key.
The following message appears:
You must now switch power o!
Messages appear when the data is saved and the application is ended.
3. Disconnect the power plug.
1. Press the [Cancel] soft key.
2. Check the SD card or insert one.
3. Press [Shutdown & Power o] again.
Process Controller Maxxis 5 PR 5900 6 System maintenance
Minebea Intec EN-314