Minebea Intec PR5900 - Fieldbus Parameters Configuration

4.6 Fieldbus parameters
In this menu item (under System setup), the parameters for the eldbus card used are
congured.
This menu item can only be selected if a eldbus card has been installed in Option FB.
Depending on the eldbus card used, the corresponding eldbus protocol appears
automatically:
- [Probus‑DP] for PR 1721/51
- [DeviceNet] for PR 1721/54
- [ProNet I/O] for PR 1721/56 and PR 1721/76
- [EtherNet IP] for PR 1721/57 and PR 1721/77
Note:
The protocol for the scale interface is described in Chapter 8.2.
The protocol for the SPM interface is described in Chapter 8.3.
Accessible via MENU – [Operating] - [System setup] - [Fieldbus parameters].
System setup @admin
Connected devices
Date & Time
Operating parameters
Network parameters
Network share connections
Fieldbus parameters
Weighing points
Display settings
License settings
User management
Alibi memory
Fieldbus parameters @admin
fieldbus protocol
I/Os
Fieldbus mode
Scale interface
IP address
Subnet mask
ProfiNet
8 byte I/O
Scale interface
WP A
192.168.1.1
255.255.255.0
Default Save
The parameters are dependent on the relevant eldbus (here: ProNet).
1. Select and conrm [Fieldbus parameters].
A selection window opens.
2. Select and conrm the individual parameters.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-88