Minebea Intec PR5900 - 4 System Setup

Operation
?
Do a cold start to finish safe mode?
Cancel Continue
3.10.2 BIOS BOOT menu in blackbox device
Since the BIOS cannot communicate with the remote terminal or VNC client, individual
menu items are triggered via the reset key and displayed via LED:
- The BIOS BOOT menu is automatically activated when ve restarts fail one after the
other.
- The BIOS BOOT menu can be accessed manually if the reset key is held down while
the device is being switched on.
If the BIOS BOOT menu is activated, the LED ashes quickly and an acoustic signal sounds
repeatedly.
The following menu items can be selected in the BIOS BOOT menu via the reset key:
Menu item Reset key LED
Cold start press once ashes once o------o------o---
Safe mode press again ashes twice oo-----oo-----oo---
Restore software from SD
card
press again ashes three
times
ooo----ooo----ooo---
3.10.3 System messages in blackbox device
The BIOS writes the messages to the temporary memory of the rmware.
5. Press the [Cancel] soft key to select additional menu items in the system maintenance
menu (ERROR RECOVERY menu) if necessary.
6. Press the [Continue] soft key to perform a cold start.
1. Press the reset key repeatedly to select other menu items.
2. Press the "Reset" button for as long as it takes (at least 2 seconds) for the LED to
illuminate continuously to conrm the selection.
Process Controller Maxxis 5 PR 5900 3 Operation and control
Minebea Intec EN-54