- System messages in blackbox device, see Chapter 3.10.3.
Note:
The BIOS BOOT menu is in English, regardless of the selected language settings.
3.10.1 Open BIOS BOOT menu
The following modes are available for a system start in the BIOS BOOT menu:
- Warm start [Warm start], see Chapter 3.10.1.1.
- Cold start [Cold start], see Chapter 3.10.1.2.
- Restore [Recover], see Chapter 3.10.1.3.
Requirements:
- The supply voltage is disconnected.
- All LEDs have gone out.
If this is not the case, the connection to the standby battery must be interrupted with the
power supply disconnected (pull the plug out carefully). Restore the connection
afterwards.
Note:
The battery is located beneath the weighing electronics board WP A, see PR 5900
installation manual.
Accessible via STOP key.
3.10.1.1 Warm start
Perform a system start via the warm start mode in the BIOS BOOT menu.
1. Hold down the STOP key.
2. Switch on the supply voltage.
The message "STOP key detected" appears.
3. Release the STOP key.
BIOS BOOT MENU
Select device boot mode
Warmstart
Coldstart
Recover
(continue from powerfail)
(reset application)
(fix unbootable system)
The BIOS BOOT menu appears.
Process Controller Maxxis 5 PR 5900 3 Operation and control
Minebea Intec EN-48
To Next Page
Loading...
