Minebea Intec PR5900 - Page 52

3.10.1.3 Restore
Replace or repair a faulty application via the restore mode (Recover) in the BIOS BOOT
menu:
- Restore from SD card [Restore last Software from SD-Card], see Chapter 3.10.1.3.1
- Load software with FlashIt! [Listen from FlashIt], see Chapter 3.10.1.3.2.
- Cold start in safe mode [Cold start in safe mode], see Chapter 3.10.1.3.3.
Accessible via STOP - [Recover] key.
BIOS BOOT MENU
Select device boot mode
Warmstart
Coldstart
Recover
(continue from powerfail)
(reset application)
(fix unbootable system)
CAL switch 2 is closed!
Please open the cal switch and press
any key.
Press ███EXIT to cancel.
This message appears if at least one CAL switch is closed.
Or: Press the EXIT key to cancel the process and return to the BIOS menu.
1. Select [Recover] with the ▼ key and conrm with the ► key/OK.
The overwrite protection statuses are checked (CAL switches and parameters
[Settings locked]).
2. Open the CAL switch and press any key to check the statuses again.
Process Controller Maxxis 5 PR 5900 3 Operation and control
Minebea Intec EN-50