Minebea Intec PR5900 - Page 51

Accessible via STOP key - [Warm start].
BIOS BOOT MENU
Select device boot mode
Warmstart
Coldstart
Recover
(continue from powerfail)
(reset application)
(fix unbootable system)
3.10.1.2 Cold start
Perform a system start via the cold start mode in the BIOS BOOT menu.
Accessible via STOP - [Cold start] key.
BIOS BOOT MENU
Select device boot mode
Warmstart
Coldstart
Recover
(continue from powerfail)
(reset application)
(fix unbootable system)
Conrm [Warm start] with the ► key/OK.
Note:
This menu item is disabled if a warm start is not possible. A warm start may not
be possible for the following reasons:
- Fatal system error
- Faulty battery
The device starts up in the same way it does after a power failure.
Select [Cold start] with the ▼ key and conrm with the ► key/OK.
Note:
If the device starts successfully, an existing database backup, if there is one, can
be re-imported (see Chapter 6.2).
The device starts, the database is cleared, and the application restarts.
3 Operation and control Process Controller Maxxis 5 PR 5900
EN-49 Minebea Intec