Minebea Intec PR5900 - Remote Terminal; Barcode Scanner (with Ex Approval)

Printer @admin
A
B
C
Interface
Printer type
Folder name
USB folder
CR/LF translation
Reports
Default Test print Save
?
Folder does not exist on USB stick.
Create folder?
Yes No
4.1.5 Remote terminal
This menu item (under Connected devices) is displayed if Maxxis is equipped with C1/
CX1.
Accessible via MENU - [Operating]- [System setup]- [Connected devices]- [Remote
terminal] .
Connected devices @admin
General devices
Remote display
ModBus-RTU master
PC via EW-Com
Printer
Remote terminal
Barcode scanner
Add. application devices
Ticket printer
Printer 2
Interface
(not assigned)
(Not assigned)
(Not assigned)
(Network printer)
(C1/CX1)
(Remote terminal TTY)
Interface
(Network printer)
(Not assigned)
Remote terminal can only
be connected via C1/CX1.
The interface used has no congurable parameters.
Note:
For further information, see PR 5900/6. and ../7. instrument manual.
4.1.6 Barcode scanner (with Ex approval)
In this menu item (under Connected devices), the parameters for a barcode scanner are
congured.
The barcode scanner is directly connected to the remote terminal PR 5900/60 or ../70.
The scanner can only be used if option CX1 is set in Maxxis.
Accessible via MENU - [Operating]- [System setup]- [Connected devices]- [Barcode
scanner] .
4. Press the [Yes] soft key.
A test le is created in the newly created folder.
5. Check the settings and change if necessary.
6. Press the [Save] soft key to save the settings.
4 System setup Process Controller Maxxis 5 PR 5900
EN-71 Minebea Intec