Minebea Intec PR5900 - Update Software with Flashit

Update software from software
Installed software
PR5900-Bios 00.02.00.138280
PR5900-Firm 00.02.00.138404
PR5900-Basic 01.00.06.4464
No labels installed.
Select software to update from
PR5900-r00-Bios 02.11.00.208007
PR5900-r00-Firm 02.11.00.208007
PR5900-Appl-Basic 01.00.04.28
2012-08-13-13:51:51
2012-08-14-06:04:36
2012-08-13-15:23:23
2014-04-28-12:34:01
2014-04-28-12:34:01
2014-03-28-11:44:03
No labels retained
Start
The software installed on the device and available in the network share connection (in
this case: "Software" folder) is listed.
Select software, see also Chapter 6.9.2.3.
Update software from software
Start
?
Press 'Next' to update the selected software
from software.
Cancel Continue
6.9.3 Update software with FlashIt
In this menu item (under Update software), the software is updated with FlashIt from a
notebook/PC.
Note:
This menu item is not available for the blackbox device.
Requirements:
- The FlashIt! program (on the CD supplied) must be installed on the notebook/PC.
- The device must be connected to the notebook/PC directly or via a network.
- The software les must be saved on the notebook/PC.
Accessible via MENU - [Operating] - [System maintenance]- [Update software]- [Update
software with FlashIt] .
3. Press the [Start] soft key to start the update.
A prompt window appears.
4. Press the [Continue] soft key.
The software is updated on the device. The device runs a cold start.
Process Controller Maxxis 5 PR 5900 6 System maintenance
Minebea Intec EN-326