Minebea Intec PR5900 - Update (Soft Key)

There are two ways to update the software:
- via soft key (one-click software update), see Chapter 6.9.1.
- via menu
- [Update software], see Chapter 6.9.2.
- [Update software with FlashIt], see Chapter 6.9.3.
- [Update software for the remote terminal], see Chapter 6.9.4.
- [Remove application], see Chapter 6.9.5.
- [Restore software from SD card], see Chapter 6.9.6.
Accessible via MENU - [Operating] - [System maintenance]- [Update software] .
System maintenance @admin
Backup
Restore
Export
Import
Alibi memory maintenance
SD card maintenance
Create service report
Shutdown & Power off
Update software
Factory reset
Test hardware
6.9.1 Update (soft key)
In this menu item (under Update software), the software on the device is replaced with
the latest software via the company network (one-click software update).
This is a simple method for when new software versions from a department are provided
on the company’s central network and these are to be installed by authorized operators.
To update the software via soft key, the following requirements must be met:
- Network share connection "ONECLICKUPDATE" has been created in the menu
[Operating] - [System setup] - [Network share connections].
Select and conrm [Update software].
Update software @admin
Update software
Update via FlashIt!
Update software for remote terminal
Remove application
Restore software from SD card
The Update software menu opens.
6 System maintenance Process Controller Maxxis 5 PR 5900
EN-315 Minebea Intec