Minebea Intec PR5900 - Modbus-RTU Master

Remote display @admin
Interface
Baudrate
Data bits
Parity
Stop bits
Built-in RS-232
9600 baud
7 data bits
even parity
1 stop bit
Default Save
Inactive parameters are grayed out.
Only the baud rate can be adjusted here.
Selection: 300, 600, 1200, 2400, 4800, 9600, 19200 baud
Note:
The selected value must match the value of the connected device.
4.1.2 ModBus-RTU master
In this menu item (under Connected devices), the parameters for a ModBus-RTU master
are congured. A serial interface is used for connection.
A maximum of two digital scale protocols are possible if [Operating] - [System setup] -
[Connected devices] - [ModBus-RTU master] has been selected in the menu.
Accessible via MENU - [Operating]- [System setup]- [Connected devices]- [ModBus-RTU
master] .
Connected devices @admin
General devices
Remote display
ModBus-RTU master
PC via EW-Com
Printer
Remote terminal
Barcode scanner
Add. application devices
Ticket printer
Printer 2
Interface
(not assigned)
(Not assigned)
(Not assigned)
(Network printer)
(C1/CX1)
(Remote terminal TTY)
Interface
(Network printer)
(Not assigned)
4. Select and conrm the desired parameters.
5. Press the [Save] soft key to save the settings.
1. Select and conrm [ModBus-RTU master].
4 System setup Process Controller Maxxis 5 PR 5900
EN-59 Minebea Intec