Minebea Intec PR5900 - Connected Devices; Remote Display

4.1 Connected devices
In this menu item (under System setup), the parameters for the connected devices are
congured.
General devices
- [Remote display], see Chapter 4.1.1.
- [ModBus-RTU master], see Chapter 4.1.2.
- [PC via EW-Com], see Chapter 4.1.3.
- [Printer], see Chapter 4.1.4.
- [Remote terminal], see Chapter 4.1.5.
- [Barcode scanner], see Chapter 4.1.6.
Accessible via MENU - [Operating]- [System setup]- [Connected devices] .
System setup @admin
Connected devices
Date & Time
Operating parameters
Network parameters
Network share connections
Fieldbus parameters
Weighing points
Display settings
License settings
User management
Alibi memory
4.1.1 Remote display
In this menu item (under Connected devices), the parameters for a remote display are
congured. A serial interface is used for connection.
Accessible via MENU - [Operating] - [System setup]- [Connected devices]- [Remote
display] .
Conrm [Connected devices].
Connected devices @admin
General devices
Remote display
ModBus-RTU master
PC via EW-Com
Printer
Remote terminal
Barcode scanner
Add. application devices
Ticket printer
Printer 2
Interface
(not assigned)
(Not assigned)
(Not assigned)
(Network printer)
(C1/CX1)
(Remote terminal TTY)
Interface
(Network printer)
(Not assigned)
The connected devices menu opens.
4 System setup Process Controller Maxxis 5 PR 5900
EN-57 Minebea Intec