Minebea Intec PR5900 - Internal Weighing Point

4.7.1 Internal weighing point
In this menu item (under Weighing points), the weighing electronics of an internal
weighing point are assigned to a logical weighing point and congured.
- [Parameters] (weighing electronics), see Chapter 4.7.1.1.
- [Calib], see Chapter 4.7.1.2.
- [New], see Chapter 4.7.1.2.1.
- [Modify] (for small changes only), see Chapter 4.7.1.2.2.
- [Units] (display units and display accuracy), see Chapter 4.7.1.3.
Accessible via MENU – [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Weighing point] - [Internal weighing point].
Weighing point A @admin
Weighing point not assigned
Save
Weighing point A @admin
Weighing point not assigned
Save
Not assigned
Internal weighing point
Liquid counter
User scale
xBPI scale
SBI scale
Pendeo Truck
Pendeo Process
PR-Net weighing point
Mettler-Scale
SMA scale
1. Conrm [Weighing point].
A selection window opens.
2. Select and conrm [Internal weighing point].
3. Press the [Save] soft key to save the settings.
The weighing electronics are now assigned to the weighing point.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-92