[F1 key], [F2 key]
Selection: [No function], Change language, Change user, Lock device, Toggle weight
unit, Set tare, Reset tare, Set tare & reset tare, Set tare & zero set, Analog test, Show
10x resolution
Note:
Weighing point functions are only active when the weight display is switched on.
Selection Function
No function Key has no function.
Change language Menus are immediately shown in the selected language.
Change user Login window appears on the display.
Lock device This function is only available when user management is
activated.
Toggle weight unit Toggle between the display units (see Chapter 4.7.1.3).
This function is only possible if at least two units have be-
en selected.
Set tare Current gross weight is saved in the tare memory.
Reset tare Switch to gross mode.
Set tare & reset tare The device will be tared if it has not been tared previously
and the tare will be reset if the device has already been ta-
red.
Set tare & zero set The device will be tared if it has not been tared previously
and the display will be set to 0.
Analog test The selected analog weighing point is tested only when
the current weight is displayed.
Show 10x resolution The weight value is briey displayed with 10x resolution.
4.4 Network parameters
In this menu item (under System setup), the network parameters are congured.
Accessible via MENU - [Operating]- [System setup]- [Network parameters] .
6. Press the [Save] soft key to save the settings.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-80
To Next Page
Loading...
