Minebea Intec PR5900 - Default (Restoring Factory Settings)

4.9.3 Default (restoring factory settings)
In this menu item (under License settings), the license numbers are reset to factory
settings.
Accessible via MENU - [Operating] - [System setup]- [License settings]- [Default] .
License settings @admin
1
2
3
Board number
Alibi license
OPC server license
Dosing license
Application license
141825064
Default Demo mode Save
License settings @admin
1
2
3
Board number
Alibi license
OPC server license
Dosing license
Application license
141825064
6955051
567
034
767
Default Demo mode Save
?
WARNING!
'Default' will remove all entered license numbers.
Cancel Continue
4.10 User management
In this menu item (under System setup), users are managed or user management is
activated (only if the device is being switched on for the rst time) or deactivated.
Note:
User management is deactivated by default.
If user management is activated and the "admin" user (administrator) is logged in, this
user can
- [Create user], see Chapter 4.10.1.
- [Copy user], see Chapter 4.10.2.
- [Change user settings], see Chapter 4.10.3.
The previous board number and license number are rewritten again.
1. Press the [Default] soft key.
A prompt window appears.
2. Press the corresponding soft key.
4 System setup Process Controller Maxxis 5 PR 5900
EN-229 Minebea Intec