Minebea Intec PR5900 - Pendeo Process

When corner correction is completed, it is marked with [Correction ok].
WP-D Max 200t d= 0.02t
Min 0.4t
0000
t
Calibration @admin
Calibration weight
Corner correction
11.000 t
correction ok
Platform 1 Save
4.7.7.4 Units
In this menu item, additional weight units for the display and the display accuracy of the
digital weighbridge load cell Pendeo
®
Truck are congured.
Descriptions and settings can be found in the [Internal weighing point] menu; see
Chapter 4.7.1.3.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Units] .
WP-D Max -------?? d= -------??
read config failed
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Pendeo Truck
Parameters Calib Units
Descriptions and settings can be found in the [Internal weighing point] menu; see
Chapter 4.7.1.3.
4.7.8 Pendeo Process
In this menu item (under Weighing points), the digital precision pressure load cell
Pendeo
®
Process is assigned to a logical weighing point and congured.
- [Interface] (serial), see Chapter 4.7.8.1.
8. Once all load cells have been loaded one time, press the [Calculate] soft key to
perform corner correction.
The total weight remains unchanged. Only the eect of the individual load cells is
corrected.
9. Press the [Save] soft key to save the corner correction.
In this case: Select [Weighing point D] with [Pendeo Truck] and press the [Units] soft
key.
4 System setup Process Controller Maxxis 5 PR 5900
EN-187 Minebea Intec