Minebea Intec PR5900 - Page 191

4.7.8.1 Interface (serial)
In this menu item, the parameters of the serial interface of the digital precision pressure
load cell Pendeo
®
Process are congured.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Interface] .
WP-D Max -------?? d= -------??
scale not ready
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Pendeo Process
Parameters Calib Units
Weighing point D @admin
Weighing point
Interface
Baudrate
Data bits
Parity
Stop bits
Pendeo Process
Option-2 RS-485-A
19200 baud
8 data bits
odd parity
1 stop bit
Default Save
Inactive parameters are grayed out.
WP-D Max -------?? d= -------??
scale not ready
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Pendeo Process
Parameters Calib Units
1. In this case: Select and conrm [Weighing point D] with [Pendeo Process].
A selection window opens.
2. Select and conrm the individual parameters.
4 System setup Process Controller Maxxis 5 PR 5900
EN-189 Minebea Intec