Minebea Intec PR5900 - Page 192

[Interface]
Serial interfaces.
Selection: not assigned, Built-in RS-232, Built-in RS-485,Option‑x RS-485‑A,
Option‑x RS-485‑B
In this case: Select [Option‑2 RS-485‑A].
[Default] soft key
Settings are reset to factory settings.
4.7.8.2 Parameters
In this menu item (under Calib), the parameters of the digital precision pressure load cell
Pendeo
®
Process are congured.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Parameters] .
WP-D Max -------?? d= -------??
scale not ready
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
xBPI scale
Pendeo Process
Parameters Calib Units
WP-D Max 200t d= 0.02t
0000
t
Weighing points @admin
Settings locked
W&M
Ambient conditions
Detect a defect load cell
Pendeo Unbalanced check deviation on WP
Standstill time
none
very stable condition
0 %
0.50 g
Default Save
[Settings locked]
The weighing point settings and assignment can only be viewed as if the
corresponding CAL switch were closed; see Chapter 2.7.1.
3. Press the [Save] soft key to save the settings.
1. In this case: Select [Weighing point D] with [Pendeo Process] and press the
[Parameters] soft key.
A selection window opens.
2. Select and conrm the individual parameters.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-190