Minebea Intec PR5900 - Page 220

— Printer O
— Host
— RS232 xed
— Dene
— Baud rate 9.600
— Bit/Parity 7/Odd
— Stop Bits 1 Stop Bit
— Handshake Xon/Xo
— End of line <CR> <LF>
— Char Set IBM/DOS
— Continuous mode O
— Second display O
— Bar code O
— External keyboard O
Example of parameter settings in the application menu
Example: Scale type XS6002SDR
Select [Peripheral devices] in the application menu and apply the following settings:
Peripheral device
4.7.10.1 Interface (serial)
In this menu item, the parameters of the serial interface for the Mettler-Scale weighing
electronics are congured.
Accessible via MENU - [Operating] - [System setup] - [Weighing points] - [Weighing
point x] - [Interface] .
WP-C Max 1.2kg d= 0.0001kg
00000
kg
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
Mettler-Scale
Pendeo Process
Parameters
1. In this case: Select and conrm [Weighing point C] with [Mettler-Scale].
A selection window opens.
Process Controller Maxxis 5 PR 5900 4 System setup
Minebea Intec EN-218