Minebea Intec PR5900 - Page 217

WP-C Max -------?? d= -------??
wrong configuration
Weighing points @admin
Weighing point A
Weighing point B
Weighing point C
Weighing point D
Internal weighing point
Internal weighing point
PR-Net weighing point
Pendeo Process
Parameters
WP-C Max -------?? d= -------??
wrong configuration
Weighing points @admin
Weighing point C
Settings locked
W&M
WP serial number
Network address
PR-Net weighing point
none
0
Default Save
[Settings locked]
The weighing point settings and assignment can only be viewed as if the
corresponding CAL switch were closed; see Chapter 2.7.1.
[W&M]
Setting for operation in legal metrology.
Selection: [None], OIML, NTEP (for USA) or NSC (for Australia), see Chapter 4.7.1.1.1.
[WP Serial number]
Serial number of the connected indicator. With serial number 0, checking is omitted.
Input range: 0 to 99999999
[Network address]
Input:
- IP address of the connected indicator or
- Host name of the connected indicator
1. In this case: Select [Weighing point C] with [PR‑Net weighing point] and press the
[Parameters] soft key.
A selection window opens.
2. Select and conrm the individual parameters.
4 System setup Process Controller Maxxis 5 PR 5900
EN-215 Minebea Intec