Minebea Intec PR5900 - Page 37

Operating @admin
Application menu
Weighing
Check weighing
Device employed as terminal
Configuration
System menu
System setup
System information
System maintenance
Logout
System menu:
- [System setup], see Chapter 4.
All parameters relating to weighing electronics can be found under [Weighing
points].
- [Connected devices], see Chapter 4.1.
- [Date and time], see Chapter 4.2.
- [Operating parameters], see Chapter 4.3.
- [Network parameters], see Chapter 4.4.
- [Network share connections], see Chapter 4.5.
- [Fieldbus parameters], see Chapter 4.6.
- [Weighing points], see Chapter 4.7.
- [Display settings], see Chapter 4.8.
- [License settings], see Chapter 4.9.
- [User management], see Chapter 4.10.
- [Alibi memory], see Chapter 4.11.
- [System information], see Chapter 5.
- [Show version], see Chapter 5.1.
- [Show status], see Chapter 5.2.
- [Show alarm information], see Chapter 5.3.
- [Show HW options] (hardware options), see Chapter 5.4.
- [Show ModBus-TCP I/O module], see Chapter 5.5.
- [Browse the Alibi memory], see Chapter 5.6.
- [Show calibration check number], see Chapter 5.7.
- [Show Pendeo data], see Chapter 5.8.
- [Show event log], see Chapter 5.9.
- [Print conguration settings], see Chapter 5.10.
- [System maintenance], see Chapter 6.
- [Backup], see Chapter 6.1.
3 Operation and control Process Controller Maxxis 5 PR 5900
EN-35 Minebea Intec