Nilfisk-Advance CS7000 Service Manual

Solution System 330Service Manual – CS7000
To Clean the Extended Scrub System Strainer
1. Open the recovery tank cover and
remove the debris basket.
2. Rinse any accumulated material off
of the Extended Scrub System Strainer
using normal water hose pressure.
3. Reinstall the debris basket and close
the recovery tank cover.
To Clean the High Pressure Solution Filter
1. Drain and remove the recovery tank.
Note: Placeasuitablecontainerunderneaththeltertocatchanysolutionthatmayleakfromthe
hoses.
2. Unscrew the Filter Cover and remove
the Filter Cover and screen from the
Filter Base.
3. Clean any accumulated dirt or debris
from the screen.
4. Reinstall the screen into the Filter
Base
.
5. Make sure the rubber washer is
installed correctly in the Filter Cover,
then reinstall and hand-tighten the
Filter Cover.
Extended Scrub
System Strainer
Filter
Base
Filter
Cover

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English