Nilfisk-Advance CS7000 - To Adjust the Squeegee Tilt

Squeegee System 348Service Manual – CS7000
To Adjust the Squeegee Tilt
1. Lower the squeegee and drive the machine forward a short distance so the squeegee assumes its normal
operating angle.
2. Check the deection angle of the Rear Squeegee Blade. It
should be approximately 45 degrees to the oor surface as
shown.
The ends of the squeegee should deect as shown while still making
full contact with the oor.
3. If the Squeegee tilt angle needs to be adjusted:
a. Lift the Crank Handle out of the
Yoke.
b. Rotate the Crank Handle to raise
or lower the 1/2”-13 Screw as
necessary so the squeegee blades
are at the correct angle to the
oor.
4. When the squeegee tilt adjustment is
correct, replace the Crank Handle into
the Yoke.
45°
Rear
Squeegee
Blade
1/2”-13
Screw
Yoke
Crank
Handle