Nilfisk-Advance CS7000 Service Manual

Squeegee System 349Service Manual – CS7000
To Adjust the Squeegee Casters
The height of the Squeegee Casters may need to be adjusted to
compensate for squeegee wear and to obtain the correct squeegee
tilt angle. To adjust the height of a Squeegee Caster:
1. Loosen the Locknut.
2. Use a wrench on the ats of the Threaded Shaft to turn the
Threaded Shaft to raise or lower the Squeegee Caster as
necessary.
3. When the Squeegee Caster is at the correct height, tighten the
Locknut.
4. Check the squeegee tilt angle and adjust as necessary. (Refer
to the To Adjust the Squeegee Tilt section on the preceding
page.)
Threaded
Shaft
Locknut
Squeegee
Caster

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English