Nilfisk-Advance CS7000 Service Manual

Solution System 340Service Manual – CS7000
To Remove and Reinstall the Solution Solenoid Valve
Service Note: You can remove and the reinstall the solution solenoid valve with the scrub deck
either in or out of the machine.
1. Empty and remove the recovery tank from the machine.
2. Remove the scrub deck from the machine (if desired). (Refer to the Scrub System section.)
3. Disconnect the Electrical Connector
on the Solution Solenoid Valve from
the adjacent wiring harness. Note
that you may need to cut the wire tie
holding the Solution Solenoid Valve
wires to the Solution Manifold.
4. Loosen the Hose Clamp holding the
Solution Solenoid Valve to the Solution
Manifold
.
5. Remove the two Hex Head Screws
holding the Solution Solenoid Valve
to the deck assembly and remove
the Solution Solenoid Valve from the
machine.
6. Reinstall the Solution Solenoid Valve
following the above steps in reverse
order.
To Remove and Reinstall a Detergent Pump (EcoFlex™ Models Only)
1. Lift up the Operator seat and engage
the Seat Prop Rod.
2. Remove the detergent bottles.
3. Remove the two Screws holding the
Cover Weldment and remove the Cover
Weldment
.
Hose
Clamp
Hex Head
Screw (2)
Solution
Solenoid
Valve
Electrical
Connector
Solution
Manifold
Seat
Prop
Rod
Screw (2)
Cover
Weldment

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English