Nilfisk-Advance CS7000 - Removal and Installation; Steering Wheel Assembly

Steering System 369Service Manual – CS7000
Removal and Installation
Steering Wheel Assembly
1. Turn the machine off, set the parking brake and disconnect the 36 V battery main power plug.
2. Lift the Rear Engine Cover (A) to access the Main Harness Connector and Steering Clamp Plate (E) on
the Steering Assembly (B) as shown.
3. Unplug the Torque Feedback Device Connector (C) from the Main Harness.
4. Remove the hardware (D) and Steering Clamp Plate (E) from the Steering Assembly (B).
5. Remove and save the (4) Pan Screws (F) and remove the Steering Assembly (B) See Detail 1.