Nilfisk-Advance CS7000 Service Manual

Steering System 372Service Manual – CS7000
13. Remove the 4 nuts and screws securing the steering wheel rotation sensor, then remove the sensor and
shaft out of the weldment.
14. Remove the nut and bolt that attaches the universal joint to the sensor shaft.
15. Reassemble in the reverse order.
a. Reassembly tip: When installing the steering pivot hardware, use a short, bent, wire hook along with
an open end wrench to position and hold the nut.

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English