Nilfisk-Advance CS7000 - Page 392

Sweep System, Main 392Service Manual – CS7000
7. Remove the Hair Cotter Pin, washers
and .50” x 1.75” Clevis Pin holding the
top of the Broom Lift Actuator to the
Spring Arm.
8. Disconnect the Broom Lift Actuator
electrical connector and remove the
Broom Lift Actuator from the machine.
9. Reinstall the Broom Lift Actuator by
following the above steps in reverse
order.
10. Check the main broom height and
main broom sweep pattern and adjust
as necessary. (Refer to the To Adjust
the Main Broom Height section.)
Hair Cotter
Pin
Spring Arm
.50” x 1.75”
Clevis Pin