Nordson Asymtek X-1000 Series - Page 380

Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 4-92 P/N 196515 (Revision A)
Is the Main Pressure
Regulator set to 80
psi?
Go to Pneumatics
Verification Procedure
Make sure facility power and
air supply is in accordance
with system requirements
Is the power and air
supply in accordance
with requirements?
Resolve before proceeding
to next step.
Are power/air
supply lines properly
connected?
Resolve before proceeding
to next step.
Resolve before proceeding
to next step.
No
Yes
No
Yes
No
Yes
Is the Main Pressure
Regulator set to 80
psi?
Is the Main Pressure
Regulator set to 80
psi?
Go to Pneumatics
Verification Procedure
Make sure facility power and
air supply is in accordance
with system requirements
Is the power and air
supply in accordance
with requirements?
Is the power and air
supply in accordance
with requirements?
Resolve before proceeding
to next step.
Are power/air
supply lines properly
connected?
Are power/air
supply lines properly
connected?
Resolve before proceeding
to next step.
Resolve before proceeding
to next step.
No
Yes
No
Yes
No
Yes
Diagram Sheet 4-7-2
Pneumatics Fault Isolation Procedure - Facility Power and Air Supply Verification