Oce PlotWave 340 Operation Guide

Set a default external location
Introduction
You can set an external location as the default location. The default location is used when you do
not select a specific external location for a job.
Procedure
1.
Select the [Configuration] - [External locations] tab.
2.
Under [External locations] select the external location you want to set as default.
3.
Click on the checkbox icon under [Default].
Set a default external location
138
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux