Oce PlotWave 340 Operation Guide

Replace the residual toner container
Introduction
A sensor detects when the residual toner container is full. When the container is full, the printer
stops printing and a message appears on the user panel: [The residual toner container is full or
not installed.] [Place the empty container.] Replace the container to continue printing.
NOTE
It is advised to replace the residual toner container every time you refill a complete toner bottle.
IMPORTANT
Do not replace the container during the printing process. You can replace the container when the
printer is on.
Procedure
1.
Open the residual toner compartment.
2.
Remove the full residual toner container.
Replace the residual toner container
278
Chapter 5 - Maintain the Printing System

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux