Oce PlotWave 340 Operation Guide

Refill the Toner
Refill the toner
Introduction
With the completely closed toner system, you can easily refill toner.
When to do
When a ‘Toner Low’ message appears on the user panel, you need to refill the toner. The
message will be displayed until you refill the toner. Under normal conditions the printer can
finish the current job, before it stops printing.
Before you begin
• You cannot add toner while printing. Wait till the printer stops printing or abort the job.
• You can leave the printer turned on when you refill the toner.
• Make sure you use toner suitable for the Océ PlotWave 340/360.
• You must use only one bottle of toner at a time. When you use more than one bottle, the
compartment will flood and toner will spill.
• When you have refilled the toner two consecutive times, you must also replace the residual
toner container. For more information, see
Replace the residual toner container on page 278.
Procedure
1.
Open the toner compartment.
Refill the Toner
Chapter 5 - Maintain the Printing System
275

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux