Oce PlotWave 340 Operation Guide

Set the alignment mode
Introduction
When you want to shift the image on the sheet, you can change the alignment mode. With the
alignment mode you can also optimise the print productivity, as you reduce the distance the print
carriage has to travel. You can, for instance, align the image to the top right hand corner of the
sheet.
You can choose the following alignment settings:
Alignment mode
[Top left] [Top] [Top right]
[Left] [Centre] [Right]
[Bottom left] [Bottom] [Bottom right]
Procedure
1.
Open the [Preferences] - [Print job defaults] tab.
2.
Click [Edit] in the [Print job defaults] section, or click on the [Alignment] setting.
3.
Select the correct value.
Select [Top right] when the print productivity is the most important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the alignment mode
160
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux