Oce PlotWave 340 Operation Guide

Do a default scan job
Introduction
When you want to scan an original and you do not make any settings the default presets are
used. You only use the Smart Access to submit your job.
You can see the presets that are used in the job settings section of your job.
Procedure
1.
Feed the original face up and centred on the original feeding table.
2.
Select the Scan tile on the user panel. The scan Smart Access is visible.
3.
Select the preferred location in the Smart Access and tap the green button.
When you do not select a location the file is sent to the public Smart Inbox.
Do a default scan job
Chapter 4 - Use the Printing System
221

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux