Oce PlotWave 340 Operation Guide

Copy by set
Introduction
You can use the [Create set] option to make multiple sets of copies.
Procedure
1.
Feed the original face up and centred on the original feeding table.
2.
Tap the copy tile. A window with a list of presets opens.
3.
In the job pane on the right, tap [Create set].
The green button changes colour and displays [Add].
4.
Tap the green button to start scanning.
5.
When the printer releases the original, insert the next original.
6.
Tap the green button. The scan is added to the set.
Repeat this step until your set is complete.
7.
Tap the [Finish set] tile, to finish the set.
Result
The printer copies the set of originals.
Copy by set
Chapter 4 - Use the Printing System
201

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux