Oce PlotWave 340 Operation Guide

Make a copy and scale to another size
Introduction
When you want to scale your copy to another size, you can make changes under the advanced
settings. With the custom setting you can choose any scale percentage you want, between the
range of 10 - 1000%.
NOTE
For more information on the other scale modes, see
Preset category:Layout on page 203.
Procedure
1.
Feed the original face up and centred on the original feeding table.
2.
Tap the copy tile. A window with a list of presets opens.
3.
Tap [All settings]. A list with settings opens.
4.
Tap [Scale] under the [Layout] preset.
5.
Tap [Scale] in the new window and select [Custom].
6.
Under [Custom] select any percentage between 10 - 1000%.
7.
After you made your settings tap [OK].
8.
Enter the number of copies and tap the green button.
Make a copy and scale to another size
Chapter 4 - Use the Printing System
213

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux