Configure the Printer Settings
Configure the regional settings
Purpose
The regional settings are configured during the installation of your printer. When you want to
change the initial configuration, you can do this under the [Regional settings].
Define the regional settings for the printer in the following order:
• [First language] and [Second language] of the user panel
• [Measurement unit]
• [Time zone]
When you change the [Time zone] you must reboot the system first, before you set the
[Current date and time].
• [Current date and time]
• [Time format]
NOTE
Every time you change the [Measurement unit], the controller recalculates the values from
millimetre to inches and vice versa. If you reverse to the original value of this setting a slight
calculation difference can occur due to rounding differences.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Regional settings] section, or click on the setting you want to edit, for
example [First language].
3.
Modify the settings. You can choose between:
• settings that are commonly used in the USA
• or settings that are commonly used in the rest of the world.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Configure the Printer Settings
Chapter 3 - Define your Workflow with Océ Express WebTools
147
To Next Page
Loading...
Need help?
General
