Oce PlotWave 340 Operation Guide

Use LPR to send a print job
Introduction
The printer supports printing through LPR.
When you send your print job through LPR the default Océ Express WebTools settings are
leading.
NOTE
You must enable printing through LPR in Océ Express WebTools.
How to send a print job via LPR
Type the following line command after the Command prompt: lpr -S <hostname or IP address> -P
<print queue name> <file name>.
NOTE
You can use any name for <print queue name>, for example jobs.
Use LPR to send a print job
184
Chapter 4 - Use the Printing System

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux