Oce PlotWave 340 Operation Guide

Set the rotation mode
Introduction
When you want to turn an image you can use the rotation settings. The setting allows you to turn
the image according to predefined rotation values, or you can let the printer perform the rotation
automatically.
Choose one of the following values:
• [No rotation]
• [90°]
• [180°]
• [270°]
• [Auto rotate portrait]
• [Auto rotate landscape]
• [Auto rotate portrait with additional 180° rotation]
• [Auto rotate landscape with additional 180° rotation]
• [Auto rotate media saving]
• [Auto rotate media saving with additional 180° rotation]
Procedure
1.
Open the [Preferences]- [Print job defaults] tab.
2.
Click [Edit] in the [Layout] section, or click on the [Rotation] setting.
3.
Choose one of the values.
Select [Auto rotate media saving] or [Auto rotate media saving with additional 180° rotation]
when the print productivity is an important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the rotation mode
Chapter 3 - Define your Workflow with Océ Express WebTools
159

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux