Oce PlotWave 340 Operation Guide

Move the Printing System
Switch the printing system off
Introduction
When you want to switch off the printing system completely, you have to take a few steps.
Procedure
1.
Use the [on / off button] at the front of the printer to switch the printing system off. The lighted
button starts to blink.
NOTE
You can also use the [Shut down] button in Océ Express WebTools.
IMPORTANT
Wait until the [on / off button] stops blinking.
2.
Switch off the [power switch] at the back of the printing system (A).
Move the Printing System
246
Chapter 5 - Maintain the Printing System

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux