Oce PlotWave 340 Operation Guide

Set the spool threshold
Introduction
When the job memory is full the printer cannot receive new jobs, therefore it is necessary to
spool the memory. Set the [Spool threshold] setting to define the spool capacity for your jobs.
You can choose one of following values:
• [Low]
Select this value when you have more small print jobs, and you want to allow a higher
capacity.
• [Normal]
This is the default setting. Select this value when you have both small and large print jobs.
• [High]
Select this value when you have more large print jobs, and you want to reduce the risk of
having to abort the file transfer due to a full job memory.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click [Edit] in the [Printer properties] section, or click on the [Spool threshold] setting.
3.
Select [Low], [Normal], or [High].
Select [Low] when print productivity is an important factor.
4.
Click [Ok] to confirm, or [Cancel] to reject your entries.
Set the spool threshold
158
Chapter 3 - Define your Workflow with Océ Express WebTools

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux