Oce PlotWave 340 Operation Guide

Make a copy on a cut sheet
Introduction
You can copy on cut sheet media when the required media type or size is not available on the
media rolls of the printer.
Procedure
1.
Feed the original face up and centred on the original feeding table.
NOTE
• The page orientation must be portrait.
• You do not need to centre the original precisely. The exact position of the original is
automatically detected by the scanner.
The Copy tile is automatically selected on the user panel.
2.
Tap the [Copy] tile. A window with a list of presets opens.
3.
Tap [All settings]. A list with settings opens.
4.
Tap [Media source] under the [Media] preset.
5.
Tap [Media source] in the new window.
6.
Select [Manual] from the list of settings.
7.
Define the number of copies and tap the green button.
8.
Wait for the media request.
9.
Place the cut sheet media on the media bypass of the printer.
Make a copy on a cut sheet
216
Chapter 4 - Use the Printing System

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux